QK-G021 V1.1 unable to deactivate the timer
QK-G021 V1.1 unable to deactivate the timer
Hello, please advise how to disable both timers on both relays of QK-G021 V1.1 . I send the required command and get a reply that Timer 1 has been switched off, but on checking the timer settings it says timer will be on at 00:00:00 and off at 00:00:00. With this type of "deactivation" the timer is still triggering the relay by making it Off and On again, whilst I would like disabled timer to have no control over the corresponding relay. Please advise how to fix that. Many thanks.
Re: QK-G021 V1.1 unable to deactivate the timer
To disable timmer, after sending GDSn(where n is the relay number, should be 1 or 2) and get the response message the operator need to restart(power off and power on again) the module to get the command active.
To ensure the relay won't take action in any case, the operator can setup an invalid turn on/off time, for example:
ON1------ after 1 there is 6 '-'
OF1------ after 1 there is 6 '-'
Hope above makes sense.
To ensure the relay won't take action in any case, the operator can setup an invalid turn on/off time, for example:
ON1------ after 1 there is 6 '-'
OF1------ after 1 there is 6 '-'
Hope above makes sense.
- napilim.pro
- Posts: 1
- Joined: Tue Oct 19, 2021 1:59 am
- Location: Russia
- Contact:
-
Agreed jsconyers.....He is just a little over excited. He has been making very nice products for a long time and is not a spammer as far as I know....
- BerniceMub
- Posts: 6
- Joined: Sun Oct 17, 2021 4:08 pm
- Location: Bermuda
- Contact:
-
Is there any way you can increase the maximum timed duration above 3 minutes and 30 seconds? It would be most helpful when one gets into working the higher percentages of 1RM sets. Thanks.
-
An excellent suggestions and something we have been considering for some time.
Thanks so much for emailing us about this and adding your vote for us to integrate this feature into XpenseTracker.
-Scott
Thanks so much for emailing us about this and adding your vote for us to integrate this feature into XpenseTracker.
-Scott